Siemens ER59553EU Bedienungsanleitung

1 Operating, installation and caring instructions ER59553EU

10 Picture 3

11 Electrical connection Prior to connection check the voltage and total output on the technical label affixed to the appliance. It is obligatory

12 Gas connection (for the fitter) The gas supply system must comply with the local standards in the country in effect. Attach the el

13

14 In compliance with the currently effective regulations, the hob must be connected to the gas pipe with a stop valve. This valve must be easily a

15 Caution Only switch on the circuit breaker or main switch once the appliance has been installed. The appliance must be installed in the furni

16 Converting the burners to another type of gas (for the fitter) Changing the nozzles Nozzles for conversion to LPG are provided with this appl

17 Nozzle table REGULATION OF MINIMUM FROM NG TO LPG 1. Light the burner and turn the knob to the minimum position. 2. Remove the knob from the t

18 2. OPERATION This is your new hob 1 Control knobs 2 Auxiliary burner, 1.0 kW 3 Semi - Rapid burner, 1.75 kW 4 Rapid burner, 2,7 kW 5 Trip

19 Ignition The knob for the relevant burner is first pushed down and turned anti-clockwise to "large flame". Press the knob down firm

2 GB Operating, installation and caring instructions page 02 English Dear Customer, We thank you and congratulate you on your choice. This practi

20 3. WHAT TO LOOK OUT FOR A few tips on pots Always use the correct pan for the correct burner! Do not

21 Notes on cooking using the wok burner The diameter of the saucepan or frying pan base must be no greater than 280 mm. Using larger pans could

22 4. CARE AND CLEANING How to care for your gas hob: Cleaning If cared for properly, your gas hob will continue to look good for a long time,

23 Your burner and burner cap • You should only start to clean the burner cap once it has cooled to its normal temperature after use, i.e. when

24 Pan support • Only clean the pan support once it has cooled to its normal temperature, i.e. when you can touch it with your bare hand. • Th

25 What has gone wrong? Probable cause Solution - Defective fuse. - Check the fuse in the main fuse box and change it if necessary. - The

26 After-sales service Our after-sales service is there for you if your hob should need to be repaired. You will find the address and telephon

27 This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).By ensuring this pro

28 Service If you should contact our Customer Service, please state E- and FD-number of your gas hob. Siemens-Electrogeräte GmbH Carl-Wery-Str

3  This appliance shall be installed in accordance with the regulations in force and only used in a well ventilated location. Read the instructions

4  If a gas tap gets stuck, do not force it. Call our service technician immediately.  Do not clean the appliance with a steam cleaning apparatus

5 CONTENTS 1. INSTALLATION ... 6 Before installation...

6 1. INSTALLATION Before installation These built-in hobs are intended for insertion into a cut out in the worktop. The appliance must only be

7 Dimensions in mm approx. 60

8 Chimney cooker hoods are to be installed in accordance with the installation instructions of the hood. On the furniture into which the a

9 Installation (for the installer) Picture 1 Picture 2 Installation must be made by a kitchen installation expert. Note: If you inte