Siemens HC15 Betriebsanweisung PDF herunterladen (Seite 6)

Getting Started with HC15

2 Installation and Configuration

HC15_startup_v02 Page 6 of 36 2007-2-16

Confidential / Released

2 Installation and Configuration

2.1 Technical Requirements for Running HC15 on DSB75

• Windows XP computer, minimum USB 1.1 connector

• HC15 module

• HC15 driver package

Modules shipped from factory have the driver package available in the mass storage and are pre-

pared for easy installation.

Please follow the installation guidelines provided below: First connect the HC15 module to the

DSB75 and start the computer (see Section 2.2). Then install the Siemens Connection Manager to

prepare the driver installation (see Section 2.3). Finally install the drivers (see Section 2.4).

• Local Administrator Privileges on the particular Windows XP computer are required to install the

Siemens Connection Manager.

• If drivers from earlier HC15 preview releases are still installed be sure to uninstall them first. See

Section 2.8

• USB cable

• DSB75 Evaluation Board providing the application interface between the HC15 USB port and the

computer's USB port.

• Adapter for mounting the HC15 module onto the DSB75

• 9 to 15 Volts power supply applied at the DSB75 for powering up the DSB75 and the connected

HC15 module

• 1 mini antenna cable (50 Ohms) from the Hirose U.FL connector on the HC15 module to the

Hirose U.FL on the DSB75; 1 external RF antenna connecting to the SMA connector of the DSB75

(product name: SMARTEQ MiniMag), both delivered with DSB75

• Metal plate for grounding the external RF antenna, min. 20 cm x 20 cm

• Optional: Handset, eg. Handset for Siemens products from Votronic delivered with DSB75

• Terminal program to control the USB port under Windows, for example Windows Hyperterminal

•UICC card

• Service provider settings for access to the GPRS and HSDPA services, as a rule the following:

- APN (network operator specific Name of Access Point that connects the GSM network to the

Internet)

- Primary and secondary DNS

- IP address (DHCP or static)

- QoS settings

- User name and password

• HC15 offers two ways to access the GPRS or HSDPA networks: either the Siemens Wireless Eth-

ernet Adapter controlled by the Siemens Connection Manager or a dial-up network connection set

up via the Siemens HSDPA USB Modem. For details see Section 3.10.

• Make sure to operate the HC15 always with the UICC card inserted in the DSB75 card reader and

a valid SIM PIN entered. This is because most AT commands require SIM PIN authentication.

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens HC15 Betriebsanweisung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Navigatoren Siemens HC15