Siemens SPCK620 Betriebsanweisung PDF herunterladen (Seite 30)

User programming via the keypad

User Menus

Siemens AB

A6V10271018

Security Products

26.09.2011

2. Press SELECT.

3. The display indicates the number of zones to be tested on the system with the

text TO TEST XX (where XX is the number of valid walk test zones). Locate the

sensor on the first zone and activate it (open the door or window).

 The keypad buzzer sounds continuously for approximately 2 seconds to

indicate that the zone activation has been detected and the number of

zones left to test (displayed on the keypad) decreases.

4. Continue with the remaining zones on the system until all zones have been

tested. If a zone activation does not get acknowledged by the system, check

the wiring of the sensor and/or replace with another sensor if necessary.

NOTICE

Only ALARM, ENTRY/EXIT and FIRE EXIT are valid zone types which are

included in a User walk test

7.1.5.3 WPA TEST

To perform a WPA test, the installer must have enrolled the WPA.

1. Scroll to TEST > WPA TEST.

2. Press SELECT.

 The keypad display flashes ACTIVATE WPA.

3. Press and hold all 3 buttons on the WPA.

 The LED on the WPA turns on.

 The WPA transmitter ID, status and signal strength are displayed on the

keypad.

7.1.5.4 AUDIBLE OPTIONS

The audible options are applied as indicators within a walk test.

To set the audible options:

1. Scroll to AUDIBLE OPTIONS.

2. Press SELECT.

3. Scroll to one of the following options: ALL, INT BELL, EXT BELL, KEYPAD

4. Press SAVE.

5. Press BACK to exit.

7.1.5.5 SEISMIC TEST

To perform a seismic test:

1. Scroll to TEST > SEISMIC TEST.

2. Press SELECT.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 42 43

Keine Kommentare

Siemens SPCK620 Betriebsanweisung Seite 30