Siemens RDG100KN Wartungshandbuch PDF herunterladen (Seite 10)

10 / 14

Siemens RDG100KN Room thermostat with KNX communications CE1N3191en

Building Technologies 01 Jun 2010

The thermostat's control parameters can be set to ensure optimum performance of

the entire system (see basic documentation P3191).

The parameters can be adjusted using

 Local HMI

 Synco ACS

 ETS3 Professional (planned)

 The control sequence may need to be set via parameter P01 depending on the

application. The factory setting is as follows:

Application Factory setting P01

2-pipe and chilled / heated ceiling, and 2-stage 1 = Cooling only

4-pipe, chilled ceiling and radiator 4 = Heating and cooling

 Recalibrate the temperature sensor if the room temperature displayed on the

thermostat does not match the room temperature measured (after min. 1 hour of

operation). To do this, change parameter P05.

 We recommend to review the setpoints and setpoint ranges (parameters

P08…P12) and change them as needed to achieve maximum comfort and save

energy.

The programming mode helps identify the thermostat in the KNX network during

commissioning.

Press the left and right buttons simultaneously for 6 sec to activate programming

mode, which is indicated on the display with "PrO

Programming mode remains active until thermostat identification is complete.

Use ETS3 Professional to assign the KNX group addresses of the RDG communi-

cation objects.

Each device has a unique KNX serial number inside the plastic housing.

An additional sticker with the same KNX serial number is enclosed in the packa-

ging box. This sticker is intended for installers for documentation purposes.

Disposal

This device is classified as waste electronic equipment under European Directive

2002/96/EC (WEEE) and may not be disposed of as unsorted municipal waste.

Adhere to all relevant national laws.

Regarding disposal, use the systems setup for collecting electronic waste.

Observe all local and applicable laws.

Control parameters

Control sequence

Calibrate sensor

Setpoint and range

limitation

Programming mode

Assign KNX group

addresses

KNX serial number

1 2 ... 5 6 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens RDG100KN Wartungshandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Thermostate Siemens RDG100KN