Siemens RDG100KN Wartungshandbuch PDF herunterladen (Seite 3)

3 / 14

Siemens RDG100KN Room thermostat with KNX communications CE1N3191en

Building Technologies 01 Jun 2010

 KNX bus (terminals CE+ and CE-) for communication with Synco or KNX

compatible devices

 Display of outside temperature or time of day via KNX bus

 Time scheduling and central control of setpoints via KNX bus

 With a Synco RMB7xx controller, the energy demand signal of the thermostat is

used to optimize energy supply.

Applications

The thermostats support the following applications, which can be configured using

the DIP-switches at the rear of the unit or a commissioning tool.

All DIP switches need to be set to OFF (remote configuration, factory setting) to

select an application via commissioning tool.

Application DIP switches

Remote configuration

via commissioning tool (factory setting)

 Synco ACS

 ETS3 professional (planned)

OFF

Heating or cooling

 2-pipe fan coil unit

 Chilled / heated ceiling

(B1)

1 2 3 4 5

OFF

Heating or cooling with electric heater

 2-pipe fan coil unit and electric heater

 Chilled / heated ceiling and el. heater

1 2 3 4 5

OFF

Use P46 / P47 to change output from ON/OFF (factory setting) to PWM

Use DIP switches 4 and 5 to change output from ON/OFF to 3-position

Note

1 2 3 4 5 6 7 8 ... 13 14

Keine Kommentare

Siemens RDG100KN Wartungshandbuch Seite 3