- 1 - ProfinetCommander User Manual V1.0 July 2006
- 10 - b) Next, the configuration download interface is set up for the PC Ethernet card. Select “Options->Set PG/PC Interface”. c) Select the E
- 11 - d) Select the PCStation and then double-click “Configuration” to bring up SIMATIC NCM PC Config (or STEP7 HW Config). e) Insert the Appli
- 12 - f) After inserting IE General the following properties screen is displayed. Select the ‘New’ button to create a new Ethernet network, normal
- 13 - g) Next, right click on the IE General Card and insert the PROFINET IO System. The Ethernet network should now be displayed as shown below
- 14 - h) Drag and drop the desired PROFINET IO devices from the catalog in the right window (under the PROFINET IO category) to the Ethernet(1) l
- 15 - i) Double-click each PROFINET IO Device to display its properties and set the Device Name. The device name must match the name in the physi
- 16 - j) Save and compile the project HW configuration by selecting the icon shown. 4.4 Download the Configuration to the PC Station a) Warni
- 17 - d) If there is an error during the download, call up the Station Configuration Editor and select the “Diagnostics” tab. Check the messages a
- 18 - 4.5 Download the PROFINET IO Device Names a) Warning: Before downloading PROFINET IO device names, make sure that ProfinetCommander is not
- 19 - 4.6 Exporting the Hardware Configuration to a File The hardware configuration must be exported to a file. The exported file provides the i
- 2 - ProfinetCommander User Manual V1.0 Table of Contents ProfinetCommander User Manual V1.0...
- 20 - 5.0 Using ProfinetCommander 5.1 Starting ProfinetCommander Start ProfinetCommander either from the Windows Desktop icon or by selecting
- 21 - 5.3 Configuration Display ProfinetCommander reads the HW Config export file and displays the configuration in a tree view in the Configurat
- 22 - 5.4 Setting the Run Mode to Operate After clicking the “Operate” button, ProfinetCommander functions as a PNIO controller and establishes c
- 23 - 5.6 Displaying Diagnostic Alarms When a diagnostic alarm is received from a PNIO Device, it is displayed in the Alarms window as shown bel
- 24 - 5.7 Reading Diagnostics A diagnostic alarm is sent from the IO device to the controller only when the error occurs. Once the controller ac
- 25 - The Diagnostic dialog shown below appears. Select the “Read Diagnostics” button in this dialog each time you want to read the diagnostics.
- 3 - 2.0 Introduction The PROFI Interface Center (PIC) in Johnson City, Tennessee has created the ProfinetCommander application, which runs as a
- 4 - Before running ProfinetCommander the SIMATIC NET CD must be installed. Warning: If you have a firewall installed on your PC, it may block the
- 5 - Set the IP address on the PC using the Windows software. Select Start->Settings->Network Connections and double-click on the appropriate
- 6 - 4.2 Edit the Station Configuration a) Execute the Station Configuration Editor by double-clicking its icon in the Windows System Tray too
- 7 - c) Select Index 1 and then use the “Add…” button to add an Application. Add Application
- 8 - d) Select Index 2 and use the “Add…” button to add the Ethernet card, “IE General”, and select the appropriate card if more than one exists
- 9 - f) Check that the Run/Stop column has green indicators. If not, select the Diagnostics tab to determine the error. 4.3 Configure the PROF
Kommentare zu diesen Handbüchern