Siemens MC55 Spezifikationen PDF herunterladen (Seite 18)

Page 18

10. Qualification

10.1 Qualification Process

The following safety precautions must be observed during all phases of the operation, usage, service or

repair of any application incorporating this Module. Manufacturers of the RF equipment are advised to

convey the following safety information to users and operating personnel and to incorporate these

guidelines into all manuals supplied with the product. Failure to comply with these precautions violates

safety standards of design, manufacture and intended use of the product. EZURiO assumes no liability

for customer failure to comply with these precautions.

10.2 Safety Information:

If the WLAN module is used in equipment that might be taken and operated on a commercial flight, the

following safety instructions, or similar warning should be added to the user manual.

“Switch off the Wireless device before boarding an aircraft. Make sure it cannot be switched on

inadvertently. The operation of wireless appliances in an aircraft is forbidden by many airlines to

prevent interference with communications systems.”

10.3 Certifications

10.3.1 FCC and Industry Canada Statements

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment.

To inherit the modular approval, the antennas for this transmitter must be installed to provide a

separation distance of at least 20 cm from all persons and must not be co-located or operating in

conjunction with any other antenna or transmitter.

Co-location with other radio transmitting devices operating concurrently in the same band will require

additional testing and certification.

Designers should note the distinction that the FCC makes regarding portable and mobile devices.

Mobile devices are defined as products that are not used closer than 20cm to the human body, whereas

portable devices can be used closer that 20cm to the body. In the case where the WISM module is

used in a portable device, additional SAR testing must be performed on the complete product.

10.3.1.1 FCC Labelling requirement

If the FCC ID is not visible when the module is installed inside another device, then the outside of the

device into which the module is installed must also display a label referring to the enclosed module.

This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID:

PI405W” or “Contains FCC ID: PI405W.” Any similar wording that expresses the same meaning may be

used.

10.3.2 National RF approvals

A list of the countries where the Module is approved will be provided by EZURiO as required. As a

minimum the product is listed in Europe, Scandinavia, Canada and USA. EZURiO assumes no liability

for customer failure to comply with national RF approval.

10.3.2.1 R&TTE Notification Requirement

The 2.4GHz band has some restrictions within the EU when the transmit power level is greater than

10mW (R&TTE Class 2). Because of this, it is designated within R&TTE as a non-harmonised band.

Such products must be notified to the appropriate Notified Body within each country where it is placed

on the market. EZURiO has notified the WISM module, but manufacturers incorporating it within their

products and intending to sell these within Europe have a responsibility to notify the appropriate

nominated body before commercial introduction. A list of nominated bodies is available at:

http://eur-lex.europa.eu/LexUriServ/site/en/oj/2003/c_302/c_30220031212en00010414.pdf

1 2 ... 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens MC55 Spezifikationen Seite 18

Kommentare zu diesen Handbüchern