Siemens GC..M.. Bedienungsanleitung PDF herunterladen (Seite 7)

GORATU MAQUINAS HERRAMIENTA,S.A.

GCM 4 / 5 / 6 / 8 / 10 5 JANUARY - 2011

4. X AXIS SLIDE

§ The X-axis slide is made from pearlitic grey cast iron, quality EN-GJL-300 (UNE-EN

1561 standard), with a hardness of 190 ÷ 220 HB, with thermal stabilization, robustly

reinforced with ribs and subjected to finite elements.

§ On the slide are located 6 long guide carriages and two independent motors for the

displacement of X-axis.

5. COLUMN

§ The column is made of pearlitic grey cast iron, quality EN-GJL-300 (UNE-EN 1561

standard), with a hardness of 190-220 HB, and is dimensioned and robustly reinforced

with inner ribs to absorb the cutting and weight forces and studied by finite elements.

§ The column and the bed are separated by an adequate distance, which enables

machining of large voluminous parts with a width greater than the table, and milling of

their rear side.

§ The column has two size-45 rolling linear guide ways for vertical slide.

6. VERTICAL SLIDE

§ The vertical slide is made of pearlitic grey cast iron, quality EN-GJL-300 (UNE-EN 1561

standard), and has a hardness of 190-220HB, robustly reinforced with ribs at the bottom

and subjected to finite elements.

§ There are 8 guide carriages for Z movement and another 6 for the Y movement, as

shown below.

Y AXIS MOVEMENT Z AXIS MOVEMENT

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Keine Kommentare

Siemens GC..M.. Bedienungsanleitung Seite 7