Siemens ITE Spezifikationen PDF herunterladen (Seite 28)

I-T-E Internal Accessories

C. Slide accessory down to rest on pad (6) trip unit. When

accessory is installed correctly, front of accessory (7) will

rest on pad (8) of line cover. Pull gently and evenly on

accessory wire leads (2 to 6 wires) while lowering

accessory into base. Make sure all the slack is removed

from leads inside breaker.

D. Replace load end cover (3), cover screws (2) and four

mounting screws if mounted. Replace terminal shield

with screws (1).

E. Add two labels to circuit breaker. Attach identification

label (11) to appropriate space in label on top of circuit

breaker on right hand side. Attach accessory informa-

tion label (12) on side of circuit breaker base (Figure 5).

F. Refer to Electrical Check, pages 27 and 28.

Recommended Combinations

Maximum Installable Accessory Combinations

Shunt

Trip(1)

Undervoltag

Trip

Auxiliary

Switch

Bell Alarm

Switch

1 0 1 0

0 1 2 0

0 0 2 0

0 0 2 1

(1) Shunt trip units include a coil clearing switch.

NOTE: See page 51 for catalog combinations.

Figure 4

Figure 5

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

Keine Kommentare

Siemens ITE Spezifikationen Seite 28