Siemens SIMATIC NET Wartungshandbuch PDF herunterladen (Seite 109)

Command Interface

5-41

SIMATIC NET CP 243-2 AS-i Master

C79000-G8976-C142/02

12 0 Parameter slave 12B Parameter slave 13B

12 1 Parameter slave 14B Parameter slave 15B

12 2 Parameter slave 16B Parameter slave 17B

12 3 Parameter slave 18B Parameter slave 19B

12 4 Parameter slave 20B Parameter slave 21B

12 5 Parameter slave 22B Parameter slave 23B

12 6 Parameter slave 24B Parameter slave 25B

12 7 Parameter slave 26B Parameter slave 27B

12 8 Parameter slave 28B Parameter slave 29B

12 9 Parameter slave 30B Parameter slave 31B

12 10 Flag 1

12 11 Flag 2

Flag 1 Flag 2

Bit Number Meaning

0 OFFLINE_READY 0 OFFLINE

1 APF 1 INTERNAL

2 NORMAL_MODE 2 EEPROM_OK

3 CONFIG_MODE 3 AUTO_ADDR_ENABLE

4 AUTO_ADDR_AVAIL 4 PERIPHERY_FAULT

5 AUTO_ADDR_ASSI_GN 5 reserved

6 LDS_0 6 reserved

7 CONFIG_OK 7 MPO startup

Flags whose values modify the AS-i master mode are shown on a gray

background.

The values of the other flags have no significance for the ’store total configuration’

command and cannot be modified on the AS-i master with this call.

Only the gray shaded flags can be modified.

CONFIG_MODE The entry ‘0’ means that the CP 243-2 changes to the protected mode after

executing the command. The entry ‘1’ means that the CP continues in the

configuration mode.

0 The AS-i master starts up in the protected mode

on completion of the job.

1 The AS-i master starts up in the configuration mode

on completion of the job.

AUTO_ADDR_ENABLE ’0’ means that the automatic address programming is disabled, ’1’ means

that the automatic address programming is enabled.

0 Automatic address programming disabled.

1 Address programming enabled.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 149 150

Keine Kommentare

Siemens SIMATIC NET Wartungshandbuch Seite 109