Siemens FIREFINDER-XLS Schnellstart Benutzerhandbuch PDF herunterladen (Seite 19)

INSTALLATION 2-1

INTRODUCTION This section provides general instructions for mounting and wiring the FireFinder-XLS

Control Panel.

Read this section before installing the equipment to ensure proper installation. If you

are not familiar with the FireFinder-XLS System, also read the first section of the

manual. Be sure to ask Siemens Building Technologies, Inc. Technical Support or an

authorized Representative if you have any questions.

Install and use the FireFinder-XLS System in accordance with the appropriate Local,

NFPA and NEC Code requirements.

INSTALLATION GUIDELINES

AlwAlw

Alw

s remos remo

s remo

ve powerve power

ve power

(battery and AC) and wait at least 10 seconds to allow the

supply voltages to decay before installing or removing any module, cable or wiring.

Follow Steps 1 through 21 for installation. Each step is thoroughly explained in the

referenced installation instructions. A description of all compatible FireFinder-XLS

system modules and devices can be found in the FireFinder-XLS Installation Instruc-

tions Index, P/N 315-034242.

1. Install the desired enclosure; CAB1, CAB2 or CAB3. Refer to the CAB

Enclosure Components table on page 2-2 to select the appropriate installation

instructions. Refer also to Figure 2-1 on page 2-3 for information on CAB

rows and module placement.

2. Install the HTSW-1 Tamper Switch where required (Refer to the HTSW-1

Installation Instructions, P/N 315-033350).

3. Pull the field wiring into the backbox and dress it to approximately where it

will go.

4. Install the PMI on the inner door (Refer to the PMI Installation Instructions,

P/N 315-033070).

5. Install the CC-5/CC-2 on a CAB-MP mounting plate (Refer to the CC-5/CC-2

Installation Instructions, P/N 315-033035). Do not install the card guides in

the CC-5/CC-2 at this time.

The Mounting Plate may be located either “IN” or “OUT” of the enclosure to

perform this installation procedure. If the Mounting Plate is located “IN” the

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 71 72

Keine Kommentare

Siemens FIREFINDER-XLS Schnellstart Benutzerhandbuch Seite 19