Siemens GS..D.. Bedienungsanleitung PDF herunterladen (Seite 20)

How to configure an Anybus PROFIBUS Slave module with a Siemens Step7 PLC

SCM-7032-026

Rev 2.1

1.6. X-gateway configuration

Use the HyperTerminal on a PC and configure the X-gateway, connect a serial cable between the PC and

the config port on the X-gateway. Open the “File” menu and click on new, choose the desired COM port and

click on OK. The following window will appear.

Figure 23 Configuring the connection in the HyperTerminal.

Make sure the settings are identical to those shown in the window above. An alternative method is to

download the HyperTerminal session file from HMS website

, double click on it and select COM port.

Connect and press ESC and the following menu will appear.

Figure 24 Anybus X-gateway Main menu.

Press 6 and enter the desired configuration. The I/O sizes are depending on the application, the I/O sizes

used in this case are just an example.The figure below shows an example; in this case a PROFIBUS Slave/

Ethernet IP X-gateway is used. The PROFIBUS Slave is configured for 10 bytes of I/O data and the

EtherNet/IP Slave for 8 bytes of I/O data.

www.Anybus.com

www.anybus.com HMS Industrial Networks AB

Page 20 (30)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Keine Kommentare

Siemens GS..D.. Bedienungsanleitung Seite 20