Siemens SIMATIC TI505 Betriebsanweisung PDF herunterladen (Seite 21)

Simatic/TI 505 Ethernet Driver Help

Checksum

STW00243 Reserved N/A N/A N/A x

STW00244 Additional Control Status Flags

Bit 1, Controller Mode 0 = Program Mode, 1 = Run

Mode

Bit 2, Scan Mode 0 = Variable, 1 = Fixed

Bit 3, User Program Source 0 = Ram, 1 = Flash

Bit 4, Ethernet Port Link Status 1 = Connected

Bit 5, TCP/IP Network Status 1 = Operational

Bit 6, Duplicate IP Address Status 1 = Duplicate

Detected

N/A N/A N/A x

STW00245 Additional Controller Error Status

Bit 1, 1 = Fatal error present

Bit 2, Reserved

Bit 3, 1 = One or more remote bases are not

communicating

N/A N/A N/A x

STW00246 Fatal Error Code. This contains the fatal error code

when a fatal error is present.

N/A N/A N/A x

STW00247-00257 CTI Support Diagnostics N/A N/A N/A x

STW00259 Product Serial Number N/A N/A N/A x

STW00260 Firmware Major Release Number N/A N/A N/A x

STW00261 Firmware Minor Release Number N/A N/A N/A x

STW00262-00298 CTI Support Diagnostics N/A N/A N/A x

STW00299 Peak Scan Time N/A N/A N/A x

STW00300-454 CTI Support Statistics N/A N/A N/A x

STW00455-00469 Remote Base Receive Errors. This contains the

number of times that the controller encountered an

error reading the response message from the

remote base.

STW 455 corresponds to remote base 1.

STW 456 – STW 469 correspond to remote bases

2 – 15.

N/A N/A N/A x

STW00470 Not used N/A N/A N/A x

STW00471-00485 Abnormal Logoff Count – Remote Base 1 - 15. This

contains the number of times that the controller

stopped communicating with the remote base due

to communications errors or response timeouts.

STW 471 corresponds to remote base 1.

STW 472 – STW 485 correspond to remote bases

2 – 15.

N/A N/A N/A x

STW00486 Not used N/A N/A N/A x

STW00487-00501 Timeout Count – Remote Base 1 – 15. This

contains the number of times that the base failed

to respond to a request from the controller within

the specified time.

STW 487 corresponds to remote base 1.

STW 488 – STW 501 correspond to remote bases

2 – 15.

N/A N/A N/A x

*For more information, refer to the register "STW200".

**Not used by the CTI 2500.

***This is only for CP575.

Alarm Addressing

The driver supports the following addresses. The default data type for each address type is indicated in bold.

www. kepware.com

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 38 39

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SIMATIC TI505 Betriebsanweisung Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller Siemens SIMATIC TI505