Siemens CA 343 Series Bedienungsanleitung PDF herunterladen (Seite 4)

Setting up the G3 for CPU communication

Once the PLC is setup, all required information is available to configure the G3. Start Crimson 2.0 software

and create a new database (via File>New). Select the device you are programming. In this example, we will be

using a G306 HMI.

Enter the “Communications” module and follow the steps as shown in figure 5:

1. Select the Ethernet port.

2. Define the port mode. In this example, it will be Manual configuration.

3. Enter the G3 IP address if required. Here 192.168.200.10.

Figure 5

Once the Ethernet port is activated, the communication driver has to be defined as follows (Figure 6):

1. Select the Protocol 1 under Ethernet.

2. On the right hand pane, click Edit to select a driver.

3. In the popup window, under Manufacturer, select Siemens.

4. Then, under Driver, select S7 300 TCP/IP Master and click OK.

A device called PLC1 should then appear under the Protocol 1. This device represents the Siemens PLC and

can be renamed to fit your application.

1 2 3 4 5 6 7 8 9 ... 17 18

Keine Kommentare

Siemens CA 343 Series Bedienungsanleitung Seite 4