Siemens SITRANS P Bedienungsanleitung PDF herunterladen (Seite 131)

UMSITRPDS3-1 On-Line Operation

November 2010

6-33

In the third example, the input spikes below minimum pressure. At t2 the response time expires and the

hold time begins. The transmitter outputs the fault current at t2 and holds that output until the hold time

expires at t3.

FIGURE 6-6 Saturation Monitoring Examples

6.4.20 Simulation

In the simulation mode, pressure and temperature values can be simulated within the transmitter without

the need for an external input signal. Transmitter circuitry can be exercised and the resulting values

output to an I/O module, controller, or other device to test the loop.

Simulation values are entered at the HART Communicator keyboard as described below. A pressure

simulation can employ either a “fixed value” or a “fixed ramp,” with the number of steps configurable.

Simulation data is stored in RAM only. Consequently, when a simulation is ended, simulation values are

deleted. Note that changing the temperatures by simulation has no effect on the measured pressure value.

Also, as long as the simulation is active, the transmitter will not react to changes in process pressure.

Figure 6-7 is a block diagram of a transmitter showing the measuring and simulation blocks.

Simulation (Pressure and Temperature)

1. In the Online menu, press 3 Device Setup.

2. In the Device Setup menu, press 2 Diagnostics/Service.

3. In the Diagnostics/Service menu, press 2 Simulation Test.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 221 222

Keine Kommentare

Modelos	Tipo de documento
60-870-13	Manual de usuario NEUE PRODUKTE 2011 - Extron Electronics, 44 paginas
KAC-6405	Manual de usuario KAC-6405, 2 paginas
FPC 5000	Manual de usuario FPC 5000 3,25x2,75 label A.eps, 1 paginas

Siemens SITRANS P Bedienungsanleitung Seite 131