Siemens AC75 Bedienungsanleitung PDF herunterladen (Seite 233)

AC75 AT Command Set

9.6 AT+CCFC

AC75_ATC_V01.002 Page 233 of 569 10/30/06

Confidential / Released

String type phone number of forwarding address in format specified by <type>. If you select <mode>= 3, the

phone <number> will be registered in the network. This allows you to disable / enable CF to the same destination

without the need to enter the phone number once again. Depending on the services offered by the provider the

registration may be mandatory before CF can be used. The number remains registered in the network until you

Type of address octect

145 dialing string <number> includes international access code character '+'

129 otherwise

Integer or sum of integers each representing a class of information, i.e. a bearer service, telecommunication ser-

vice or bearer service group as defined in "GSM 02.04"

1voice

2data

<class> 2 (data) comprises all those <class> values between 16 and 128, that

are supported both by the network and the MS. This means, a setting made for

<class> 2 applies to all remaining data classes (if supported). In addition, you

can assign a different setting to a specific class. For example, you can activate

Call Forwarding for all data classes, but deactivate it for a specific data class.

4fax

8SMS

16 data circuit sync

32 data circuit async

64 dedicated packet access

128 dedicated PAD access

1...[7]...255 combination of some of the above classes. For example, the default setting 7

represents the sum of the integers 1, 2 and 4 (CF for voice, data and fax). The

value 255 covers all classes. If the <class> parameter is omitted, the default

value 7 is used.

5...[20]...30 Time to wait before call is forwarded, rounded to a multiple of 5 sec. (only for

<reason>=no reply)

0 Call Forwarding not active

1 Call Forwarding active

Notes

• You can register, disable, enable and erase <reason> 4 and 5 as described above. However, querying the

status of <reason> 4 and 5 with AT+CCFC will result in an error ("CME error: Operation not supported"). As

an alternative, you may use the ATD command followed by *'# codes to check the status of these two reasons.

See Star-Hash (*#) Network Commands for a complete list of *# GSM codes. See also examples below.

• Most networks will not permit registration of new parameters for conditional call forwarding (reasons 1,2,3,5)

while unconditional call forwarding is enabled.

•The AT+CCFC command offers a broad range of call forwarding options according to the GSM specifications.

(str)

<type>

(num)

<class>

(num)

<time>

(num)

(num)

1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 568 569

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens AC75 Bedienungsanleitung Seite 233

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mobiltelefone Siemens AC75