Siemens SISTORE AX16 Bedienungsanleitung PDF herunterladen (Seite 23)

Installation

Siemens Building Technologies

Fire Safety & Security Products 12.2008

NOTE

The SCSI bus must be terminated, otherwise the DVR will not operate properly.

NOTE

When using low speed SCSI devices, the recording speed might decrease.

IMPORTANT

Do not connect or disconnect SCSI devices while the DVR power is on. The DVR

must be powered down to connect or disconnect SCSI devices. Power up SCSI

devices so they are ready for operation before powering up the DVR. Power down

SCSI devices after powering down the DVR and then disconnect SCSI devices.

NOTE

If the SCSI device is shut down while the device is operating, the DVR system might not operate

normally

7.10 Connecting to the network port

Fig. 17 Network connector

The DVR can be networked using the 10/100Mb Ethernet connector. Connect a

Cat5 cable with an RJ-45 jack to the DVR connector. The DVR can be networked

with a computer for remote monitoring, searching, configuration and software

upgrades. See the Section 8: Configuration for configuring the Ethernet

onnections.

NOTE

The Network connecter is not designed to be connected directly with cable or wire intended for

outdoor use.

7.11 Factory reset

Fig. 18 Factory reset switch

The DVR has a factory reset switch to the left of the USB port on the rear panel.

This switch will only be used on the rare occasions that you want to return all the

settings to the original factory settings.

NOTE

When using the Factory Reset, you will lose any settings you have saved.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 125 126

Keine Kommentare

Siemens SISTORE AX16 Bedienungsanleitung Seite 23