Siemens SISTORE AX16 Bedienungsanleitung PDF herunterladen (Seite 24)

Installation

Siemens Building Technologies

Fire Safety & Security Products 12.2008

To reset the unit, you will need a straightened paperclip:

1. Turn the DVR off.

2. Turn it on again.

Î While the DVR is initializing, the front panel LEDs will blink.

3. When any of the Camera 1 to 8 LEDs blink, poke the straightened paperclip in

the unlabeled hole to the left of the USB port.

4. Hold the switch until all the LEDs on the front panel are lit.

NOTE

When the DVR successfully resets to factory defaults all the LEDs on the front panel flash five times.

5. Release the reset switch.

Î All of the DVR’s settings are now at the original settings it had when it left the

factory.

7.12 Connecting the power cord

Fig. 19 Power cord connector

Connect the AC power cord to the DVR and then to a wall outlet.

IMPORTANT

The power cord must be connected to the DVR before it is connected to a wall

outlet, otherwise, the DVR might NOT be powered up properly. If the DVR is not

turned on after connecting the power cord, disconnect the power cord, wait 10

seconds, and restart the DVR by following the proper connection procedures.

CAUTION

Route power cords so that they are not a tripping hazard. Make certain the

power cord will not be pinched or abraded by furniture. Do not install power

cords under rugs or carpet.

CAUTION

The power cord has a grounding pin. If your power outlet does not have a

grounding pin receptacle, do not modify the plug.

Do not overload the circuit by plugging too many devices in to one circuit.

Your DVR is now ready to operate. Refer to Sections 8: Configuration and

9: Operation.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 125 126

Keine Kommentare

Siemens SISTORE AX16 Bedienungsanleitung Seite 24