Siemens AC75 Bedienungsanleitung PDF herunterladen (Seite 346)

100

101

AC75 AT Command Set

11.19 ATD*98#

AC75_ATC_V01.002 Page 346 of 569 10/30/06

Confidential / Released

11.19 ATD*98# Request GPRS IP service

This command causes the MT to perform whatever actions are necessary to establish a communication between

the TE and the external PDN.

The V.250 'D' (Dial) command causes the MT to enter the V.250 online data state and, with the TE, to start the

layer 2 protocol.

GPRS attachment and PDP context activation procedures may take place prior to or during the PDP startup if

they have not already been performed using the AT+CGATT and AT+CGACT commands.

To confirm acceptance of the command before entering the V.250 online data state command will respond with

CONNECT.

When the layer 2 protocol has terminated, either as a result of an orderly shut down of the PDP or an error, the

MT enters V.250 command state and returns NO CARRIER (for details refer to Section 11.5.1, Automatic deac-

tivation of PDP context during dial-up PPP).

Syntax

Parameter Description

Parameter specifies a particular PDP context definition (see AT+CGDCONT command). If no context is specified,

an internal context with default properties is used (see AT+CGDCONT, AT+CGQREQ and AT+CGQMIN).

1...2

Notes

• If AC75 is in dedicated mode, command returns the result code BUSY.

• ATD is used as a standard V.250 AT command, too.

Exec Command

ATD*98[* <cid>]#

Response(s)

CONNECT

NO CARRIER

Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

GSM 07.07 + + + + + + + - - +

<cid>

(num)

1 2 ... 341 342 343 344 345 346 347 348 349 350 351 ... 568 569

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens AC75 Bedienungsanleitung Seite 346

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mobiltelefone Siemens AC75