Siemens DTU3005-B Betreibershandbuch PDF herunterladen (Seite 65)

Appendix A: Supported PLCs

Siemens Energy & Automation, Inc. 61

p1 T0 0 (for PC COM Port 1)

p2 T0 0 (for PC COM Port 2)

For example, if you are using a 545 PLC and you are

using COM2 on your PC, you would invoke TISOFT as

follows:

TI545 p2 T0 0

These parameters will prevent the programming soft-

ware from switching over to the Transparent Byte Pro-

tocol, which is not supported by the DTU3005.

A.15 Toshiba EX and M Series PLCs

Registers Accessed

The DTU3005 will only access registers in the Data

9999) should be entered. For example, to access regis-

ter number D0, the value 0 should be entered. To

access register number D9999, the value 9999 should

be entered.

Protocols Supported

The DTU3005 will only communicate with Toshiba EX

and M Series PLCs using the Binary Computer Link

protocol.

A.16 Toshiba T Series PLCs

Registers Accessed

The DTU3005 will only access registers in the Data

9999) should be entered. For example, to access regis-

ter number D0, the value 0 should be entered. To

access register number D9999, the value 9999 should

be entered.

Protocols Supported

The DTU3005 will only communicate with Toshiba T

Series PLCs using the ASCII Computer Link protocol.

A.17 Westinghouse PLCs

Registers Accessed

The DTU3005 will only access registers in the Holding

ing register numbers, only the offset into this area (1-

9999) should be entered. For example, to access regis-

ter number HR1, the value 1 should be entered. To

access register number HR9999, the value 9999

should be entered.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 140 141

Keine Kommentare

Siemens DTU3005-B Betreibershandbuch Seite 65