Installation instructions and notes on usage
D.3 Assembly instructions for SIMATIC NET PROFIBUS plastic fiber-optics with simplex connectors
PROFIBUS Network Manual
System Manual, Edition 04/2009, C79000-G8976-C124-03
297
7. Open the handles of the pliers slowly until the grip
releases the core. Take the core out of the pliers.
Only then should you open the handles fully again.
Notice: If the handles are opened fully before the core is
removed, the fiber may be damaged as the blade retracts.
8. Repeat the same steps with the second core.
Table D- 5 Installing simplex connectors
1. Insert the core into the simplex connector as far as the
limit stop ① fold down the top half of the grip ②.
Notice: The fiber must extend at least 1.5 mm beyond the
face of the connector.
2. Press the two halves of the grip together until you
hear them lock together.
3. Repeat the same steps with the second core.
Notice: Do not insert the connector into the device socket
yet, the excess fiber could damage the send and receive
elements.
Kommentare zu diesen Handbüchern