
Application Examples
Commissioning over W-LAN
18/7
Siemens ET G1 · 10/2008
■
Overview
Commissioning – Now you can do it yourself
In every GAMMA instabus project, the devices are commissioned
once they have been installed. First you need to assign the
physical
addresses. To do this, select the device in the ETS3
(KNX commissioning software) on your notebook and press
the programming pushbutton on the device. In the case of
distributed devices, such as flush mounting bus coupling
units, this means a lot of running around! One reason why
these commissioning tasks are usually carried out in pairs.
But now you no longer have to go to all this trouble. Simply
wirelessly connect your notebook to the KNX over W-LAN. And
now you are free to roam during the commissioning process –
simply take your notebook with you, wherever it's needed. It
really couldn't be any quicker or easier. And there is no risk of
errors, such as mixing up the devices due to ambiguous calling.
The solution:
The benefits:
• Wireless GAMMA
instabus
commissioning over W-LAN
• Freedom of movement within the building
• Single-person commissioning
Proceed as follows:
Connect the N 148/21 IP interface to the KNX, connect the
W-LAN router to the IP interface using the Ethernet cable – and
you're off - free to roam the entire building with your notebook
and the ETS.
You require the following:
• N 148/21 IP interface (5WG1 148-1AB21)
• 24 V power supply for N 148/21 IP interface
(e.g. 4AC2 402)
• Ethernet
•W-LAN router
• W-LAN-capable notebook
• ETS3 (current version see http://www.knx.org)
Note:
W-LAN stands for Wireless Local Area Network. W-LANs are quick and easy
to install, cover large areas and operate cost-effectively.
KNX device
Notebook W-LAN-capable
W-LAN router
KNX device
KNX device
W-LAN
(wireless)
LAN
(Ethernet cable)
N 148/21
IP interface
I2_15411
KNX
ET_G1_2009_en.book Seite 7 Freitag, 28. November 2008 9:50 09
Kommentare zu diesen Handbüchern