Machining the machining step program manually
6.4 Executing the machining step program
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
121
Operating sequences, executing the machining step program
The current machining status is displayed in the center of the execute screen (see the
screen "Executing the machining step program"). This status could be one of the following:
● Machining not started
● Machining active
● Machining aborted
● Machining interrupted
● Machining finished
In the example, the text "Machining not started" is displayed.
1. Start machining using the <NC-Start> key.
The machining operation on the workpiece is executed.
The individual machining steps are executed in the order in which you program them.
Note
Press the <NC-Stop> key if you want to interrupt the machining operation.
2. If machining was terminated (e.g. "machining completed"), then the execution screen can
be exited using the "Cancel" softkey.
Note
The individual machining steps are performed with the currently programmed direction of
spindle rotation! This need not coincide with the position of the spindle direction switch or
with the spindle direction selected with the spindle keys!
$ERUW
Kommentare zu diesen Handbüchern