Manual machining
5.4 Manual machining using cycles (functions)
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
57
Note
Press the <NC-Stop> key if you want to interrupt the machining operation. The selected
direction of the spindle rotation continues to be activated.
By pressing the key <NC stop>, the operating mode JOG is automatically changed, i.e.
you can traverse the axes manually. By continuing the execution with <NC start>, the
interruption point is approached again and execution of the program is continued.
5. If machining was terminated (e.g. "Machining completed"), then the execution screen can
be exited using the "Cancel" softkey.
See also
Messages (Page 123)
$ERUW
Kommentare zu diesen Handbüchern