Manual machining
5.2 Display and operator control optios in the main screen for "Manual Machine Plus"
Manual Machine Plus Turning
Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0
35
Controlling the axes and spindle
In manual machining mode, the axes and spindle can be controlled by the following
methods:
● The compound slide rest is controlled by:
–
Handwheels (Page 39) for the X and Z axes, or
–
Axis direction switch (Page 39)
● The spindle is controlled by:
–
Spindle direction of rotation switch (Page 40)
Values displayed in the position display and T, F, S
Figure 5-2 Main screen for "Manual Machine Plus", position display relative
Displayed values Meaning
In front of axis letters
+/-
• Current traversing direction of axes
S value/S type %
• The programmed value for either the spindle speed (rev/min) or the cutting rate (m/min)
The display corresponds to the settings for the machining technology data.
• Current position of the spindle override switch in %.
F value/F type %
• Programmed feed value
in either "m/min" or "mm/Rev", depending on the settings for the machining technology data.
• Current position of the feedrate override switch in %.
T value
• Tool number of the tool used
D value
• Tool offset applied
INC value
• Handwheel pulse weighting setting
Kommentare zu diesen Handbüchern