Siemens C10 Betriebsanweisung PDF herunterladen (Seite 33)

HWC_SoftwareConfig.fm

A31003-W1010-A100-1-7619, July 2005

HiPath Wireless Controller, Access Points and Convergence Software V3.0: User Guide

Controller, Access Points and Convergence Software configuration

Configuration steps: overview

4 Controller, Access Points and Convergence

Software configuration

4.1 Configuration steps: overview

To set up and configure the HiPath Wireless Controller and Wireless APs, follow these steps:

1. First-time Setup: Perform “First-Time Setup” of the HiPath Wireless Controller on the

physical network to modify the Management Port IP address for the enterprise network.

2. Product Key: Apply a Product Key file, for licensing purposes. If no Product Key is enabled,

the HiPath Wireless Controller functions with all features enabled in demonstration mode.

3. Data Port Setup: Set up the HiPath Wireless Controller on the network by configuring the

physical data ports and their function as “host port”, “router port”, or “3rd party AP port”.

4. Routing Setup: For any port defined as a “router port”, configure static routes and OSPF

parameters, if appropriate to the network

5. Wireless AP Initial Setup: Connect the Wireless APs to the HiPath Wireless Controller.

They will automatically begin the “Discovery” of the HiPath Wireless Controller, based on

factors that include:

● their Registration mode (in the Wireless AP Registration screen)

● the enterprise network services that will support the discovery process.

6. Wireless AP Configuration: Modify properties or settings of the Wireless AP, if desired.

7. Virtual Network Services (VNS) Setup: Set up one or more virtual subnetworks on the

HiPath Wireless Controller. For each VNS, configure the following:

● Topology: configure the VNS, and assign the Wireless APs radios to the VNS.

● Authentication and Accounting: configure the authentication method for the

wireless device user and enable the accounting method.

● RADIUS Policy: define Filter ID values for user groups

● Filtering: define filtering rules to control network access

● Multicast: define groups of IP addresses for multicast traffic

● Privacy: select and configure the wireless security method on the VNS.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 249 250

Keine Kommentare

Siemens C10 Betriebsanweisung Seite 33