Siemens C10 Betriebsanweisung PDF herunterladen (Seite 35)

HWC_SoftwareConfig.fm

A31003-W1010-A100-1-7619, July 2005

HiPath Wireless Controller, Access Points and Convergence Software V3.0: User Guide

Controller, Access Points and Convergence Software configuration

Setting up the data ports

4.3 Setting up the data ports

The next step in the initial setup of the HiPath Wireless Controller is to configure the physical

data ports.

Configuring the data port interfaces on the HiPath Wireless Controller

1. Click on the HiPath Wireless Controller tab. In the HiPath Wireless Controller

Configuration screen, click on the IP Address option. The Management Port Settings and

Interfaces screen appears.

The lower portion of the HiPath Wireless Controller Configuration screen displays the

Interfaces, either the four ethernet ports (for the C10 and C100), or the two ports (for the

C1000). For each port, the MAC address is displayed automatically.

2. Click in a port row to highlight it.

3. For the highlighted port, key in the:

IP address IP Address of the physical ethernet port.

Subnet mask For the IP address, the appropriate subnet mask to separate the

network portion from the host portion of the address (typically

255.255.255.0)

MTU Maximum Transmission Unit (maximum packet size for this port).

Default setting is 1500. If you change this setting, and are using OSPF,

be sure that the MTU of each port in the OSPF link matches.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 249 250

Keine Kommentare

Siemens C10 Betriebsanweisung Seite 35