Siemens Sinumerik 810T Bedienungsanleitung PDF herunterladen (Seite 42)

EMCO WINNC SINUMERIK 810/820 T

D 10

PROGRAMMING

G48 Leave as Approached

Format

N... G48 X... Y... U...

To avoid cutting marks, a contour will be approached

and left tangentially. To approach and leave the

following functions are available:

G147 Soft approach to contour with linear

G247 Soft approach to contour with quarter circle

G347 Soft approach to contour with semicircle

G48 Leave as approached

G148 Soft leaving the contour with linear

G248 Soft leaving the contour with quarter circle

G348 Soft leaving the contour with semicircle

see G147 - G348

With calling up G48, G41 or G42 must be active.

G48 causes, that the contour will be left in the same

way like it was approached.

G48 is effective blockwise.

After the G48 block G40 is active automatically.

G50 Cancel Scale Modification

G51 Scale Modification

Format:

N... G50

N... G51 X... Z... P...

With X and Z the base point (P

) for scale modifica-

tion is determined, with P the scale factor.

If X and Z are not determined, the work piece zero

point (X = 0, Z = 0) is used as base point.

By scale modification the following values will be

calculated:

• axis coordinates

• interpolation parameter

• radius / chamfer

• programmable zero offset

Enlarging a contour

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 89 90

Keine Kommentare

Siemens Sinumerik 810T Bedienungsanleitung Seite 42