Siemens Sinumerik 810T Bedienungsanleitung PDF herunterladen (Seite 61)

EMCO WINNC SINUMERIK 810/820 T

D 29

PROGRAMMING

Contour definition

This way of programming can be used if intersection

point coordinates are missing. Multiple point drafts

for contour definition are offered in different forms

and may be combined at will. Intersection points will

be calculated by the software from coordinate values

or angles.

Angles are always related to the +Z direction.

The following contour drafts are offered:

Insert Chamfer

For chamfers B is entered as negative number.

G1 X2... Z2... B-... LF

G1 X3... Z3... LF

Insert Radius

For radii B is entered as positive number. The en-

tered radius must not be larger than the smaller one

of the two lines.

G1 X2... Z2... B+... LF

G1 X3... Z3... LF

Line

By entering the angle A and one target point coordi-

nate the line will be computed.

G1 A... X... or G1 A... Z...

Arc

Description of the arc by radius B, centre point I, K

and one target point coordinate.

G2 I... K... B... X2... or G2 I... K... B... Z2...

Angles refer to the +Z direction

Inserting a chamfer

Arc defined by radius, centre and one end coordinate

Inserting a radius

Line determined by angle and one end coordinate

A=144°

A=220°

X2+Z2

X3+Z3

-B

X2+Z2

X3+Z3

X / Z

X2 / Z2

X1+Z1

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 89 90

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens Sinumerik 810T Bedienungsanleitung Seite 61

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Siemens Sinumerik 810T