Siemens Pacemaker UM344-2 Bedienungsanleitung PDF herunterladen (Seite 10)

UM344-2 INTRODUCTION

September 1995

1.0 INTRODUCTION

This User’s Manual is for the XTC™ Model 344 Smart Temperature Transmitter. It covers both the

Transmitter-Controller and Transmitter only versions.

NOTE

Throughout this Manual the term Transmitter will include both versions

except when the Transmitter-Controller is specifically stated and when

discussing unique Transmitter-Controller features, such as the Controller

function block.

All information needed to bench test, install, configure, system test, and service a transmitter is included in

this User’s Manual. Figure 1-1 shows the basic Model 344. Figure 1-2 shows the two terminal strips for

loop, sensor, display, and test equipment connections.

IMPORTANT

Save this User's Manual for installing, configuring, operating and servicing

a Model 344 transmitter.

1.1 SECTION CONTENTS

Nine sections make up this Manual. A brief description of each section follows.

Section 1, INTRODUCTION, describes each section in this Manual and provides a brief description of

the Model 344 Smart Temperature Transmitter line.

Section 2, XTC COMMUNICATOR (MXC), describes use of the MXC to test, configure, and calibrate a

transmitter.

Section 3, INITIAL TRANSMITTER SETUP, provides procedures to perform a bench test of the

transmitter to ensure proper operation of all functions. Start-up configuration is described here. If desired,

go to Section 5 to perform a complete configuration.

Section 4, INSTALLATION, furnishes specific information for mechanical and electrical installation.

Section 5, ON-LINE AND OFF-LINE OPERATION, describes on-line and off-line configuration, and

the use of the transmitter’s zero and full-scale pushbuttons.

Section 6, CALIBRATION AND MAINTENANCE, provides calibration procedures for analog and

digital modes. It also furnishes preventive maintenance, troubleshooting, and assembly replacement

procedures. A spare and replacement parts list is provided at the back of this Manual.

Section 7, CIRCUIT DESCRIPTION, contains an assembly level circuit description to support transmitter

servicing.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 182 183

Keine Kommentare

Siemens Pacemaker UM344-2 Bedienungsanleitung Seite 10