Siemens Pacemaker UM344-2 Bedienungsanleitung PDF herunterladen (Seite 60)

INSTALLATION UM344-2

September 1995

3. At the Electronics Module, remove the meter mounting bracket attached to the left corner of

bottom circuit board . Install bracket in right front corner of that circuit board.

Hex Stand-Off

and

Digital Meter Assembly

Mounting Screw

Bracket and

Digital Meter Assembly

Mounting Screw

Note 2

90 and 270 Digital Meter

Mounting Hardware Location

o o

0 and 180 Digital Meter

Mounting Harware Locations

Notes:

1. Enclosure Cap and Digital Meter removed to show Meter mounting hardware.

2. Bracket screwed to the Electonics Module.

3. Meter orientations relative to Transmitter body are shown.

4. Jumper W1, Zero and Full Scale Pushbutton Enable/Disable:

Enable - jumper pins 2 & 3

Disable - jumper pins 1 & 2.

5. When installing an Electronics Module, guide blocks must engage guide posts in

housing. P1 power connector on Module must engage connector on baseboard.

Electronics Module

Notes 1 and 5

X028AAS0

Meter Orientation

Note 3

Connector P2,

for Ribbon Cable

to Digital Meter

W1, Note 4

Electronics Module

Securing Screw

Guide Blocks

FIGURE 4-9 Digital Meter Orientation and Mounting Hardware

4. Rotate the Digital Meter assembly either CW or CCW 90° (to the 90° or 270° position), slip the

assembly under the retaining screws, and tighten both screws.

5. Position the cable in the cable slot and insert the cable connector into the closest connector (J2 or

J4).

6. Replace the enclosure cap and restore power to transmitter.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 182 183

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens Pacemaker UM344-2 Bedienungsanleitung Seite 60

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Messen, Testen & Steuern Siemens Pacemaker UM344-2