Siemens OSM Betriebsanweisung PDF herunterladen (Seite 145)

The name of the fibre channel port that connects the router to the FCSA.World Wide Port Name

The part number of the component that was assigned in manufacturing. Use

part numbers for identifying and ordering parts.

Part Number

Indicates whether IP address assignment by DHCP (for this router) is enabled

or disabled.

DHCP Setting

The IPv4 address of the router. Currently supported model: M8201.IPv4 Address

The version of the ROM on the router.ROM Version

Indicates whether the fibre channel port connecting the router to the FCSA

is up or down.

FC Port Status

A unique identification number assigned to each switch in manufacturing.Serial Number

The version of the firmware running on the router.Firmware Revision

Indicates whether the router is Up or Down.Device Status

Associated Device

The names of the one or two tape drives associated with the router.Tape Drive

Physical Location

The values displayed by these attributes are assigned through the Physical Configuration Tool.

A user-defined name assigned to identify the rack in which the Fibre Channel

Router is located.

Rack Name

A number (from 1 to 42) assigned to describe the location of the Fibre

Channel Router within the rack.

Rack Offset

Actions

Link to Web Interface

Opens a Web interface that provides detailed device configuration and information for the router.

Rediscover

Causes OSM to refresh and reanalyze the object. Refresh refers to OSM updating the attribute

values displayed in the OSM Service Connection interface. Reanalyze refers to the running of

OSM incident analysis, which checks EMS event messages and creates alarms in OSM if certain

conditions exist.

Stop Monitoring

Stops OSM from monitoring the router.

FSAC (Fiber ServerNet Addressable Controller)

The Fiber SAC (ServerNet addressable controller) is a fiber-optic plug-in card mounted on the

ServerNet/DA CRU. External storage devices are physically connected to the Fiber SACs. There

can be up to four Fiber SACs on each ServerNet/DA CRU.

Location in OSM Tree: System > Group > Module > SNDA > FSAC

Example: FSAC (11.1.53.1)

FSAC (Fiber ServerNet Addressable Controller) 145

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 305 306

Keine Kommentare

Siemens OSM Betriebsanweisung Seite 145