Siemens OSM Betriebsanweisung PDF herunterladen (Seite 184)

Delete the Power Source Configuration

Sets the Configuration > Power Supply attribute value to Not Configured. You must be logged on

as super.super to perform this action.

Power Supply (Processor Switch)

One of two FRUs that supply power for the components in a processor switch.

Attributes

Physical

A code that identifies the generation of the component. Hardware revision

codes are used for tracking components.

Hardware Revision

Indicates whether or not the power supply’s amber LED is lit. This state is

determined by the Set LED State action.

Value: On or Off

LED State

The part number of the component that was assigned in manufacturing. Use

part numbers for identifying and ordering parts.

Part Number

A unique serial number that identifies the component. Track IDs are used for

tracking components.

Track ID

Logical

The state of the component as known to the operating system on the server.

Values

Device State

Configuration

Indicates the state of this power supply unit's backup power configuration

as known to OSM.

Values: Not Configured, AC, UPS, Unknown

Power Source

You must use the Configure Power Source as UPS action to set this value to

UPS in order for OSM to provide an orderly system shutdown in the event

that a power failure exceeds the powerfail-delay time interval specified for

your rack-integrated UPS.

The IPv4 address of the UPS configured to provide backup power in the event

of a power failure, if specified through the Configure Power Source as UPS

action.

UPS IPv4 Address

Actions

Configure Power Source as AC

Sets the Configuration > Power Supply attribute value to AC. You must be logged on as super.super

to perform this action.

Configure Power Source as UPS

Sets the Power Source attribute value for this power supply unit to UPS. You must be logged on as

super.super to perform this action. Upon initiating the action, you are prompted to enter the IPv4

address of the UPS.

For Integrity NonStop NS16000 series servers, you must use this action to configure at least one

of your processor switch power supplies (to specify UPS as the backup power source) in order for

OSM to provide an orderly system shutdown in the event that a power failure exceeds the

184 System Resources

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 305 306

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens OSM Betriebsanweisung Seite 184

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Siemens OSM