
New features and changes as of version 9.07
13
Building Technologies
Fire Safety & Security Products
2 New features and changes as of version 9.07
2.1 New features
All the features that are new as of version 9 07 are listed below.
z P25E 3E: Dial Report delay
refer to chapter
13.3: Dial report delay
z P25E 13E Option 6: Allow monitored Keypad Bus Output Board
refer to chapter
14.3: Miscellaneous user options
z P25E 13E Option 8: Limited Events & Dialer to 3 of any one type
refer to chapter
14.3: Miscellaneous user options
z P36E Option 5: Output disabled when P25E 3E timer is running
refer to chapter
16.1: Output options
z P37E Option 4: Disable outputs during two way voice mode
refer to chapter
16.1: Output options
z P46E Option 7: Cannot Arm if Zone unsealed at end of Exit Delay
refer to chapter
17.1: Area arm and special function options
z P122E Option 3: Not on Exit Delay Time
refer to chapter
20.2: Zone type options- basic information
z P175E 2E Option 8: Allow the panel to auto-answer after 1 ring if set up to do fill
duplex two way voice
refer to chapter
22.1: Dialer options
z P183E Option 5: Allow for direct on-line two way voice following reporting of an
alarm event
refer to chapter
23.3: Telephone number report options
z P200E Option 13: Installer code
refer to chapter
27.7: Installer code
z P200E Option 14: RSSI
refer to chapter
27.8: Radio Signal Strength Indication
2.2 Changes
Walk test now exits back to program mode if you will press on for exit.
On previous version when you pressed on
to terminate walk test the panel was
get out from program mode. Now when you press
to terminate walk test the
panel stay on program mode.
When Learning Radio device not found now shows Not Found! instead of
non-descriptive Done (for zone and pendant).
When entering to learning mode and no device was found, the panel will present
the message Not Found! (Instead of the message Done on the previous
version).
Kommentare zu diesen Handbüchern