Siemens IC60 Bedienungsanleitung PDF herunterladen (Seite 167)

Support

167

Building Technologies

Fire Safety & Security Products

When you have several phone numbers defined the CP stops dialing after the

first phone number?

Answer: There can be two reasons for that, the first is if you disarm the system

during the call , when the system is disarmed it finishes the call and doesn’t go on

to the next numbers since the alarm is acknowledged , unless you are in Contact

ID format then you have another dial to report disarm to the monitoring station.

Another possibility is in domestic/voice dialing format. Normally the auto kiss of is

on then you can't put the option “stop if kiss-off” on since it will always be kissed-off

since will never go next numbers.

I have defined a follow-up zone and have no delay when I enter, why?

Answer: When you define a follow up zone (handover) and a delayed zone, first

the zone numbers should be following (for example 1 & 2 or 3 & 4) and second the

delay time must be the same.

Do I need a separate unit to program the audio verification board?

Answer: The audio verification board has a micro and loudspeaker integrated and

can be programmed directly in place without any additional units.

Is there a PSTN dialer integrated in the control unit?

Answer: Yes with 8 different Telephone numbers.

31.2 Typical programming guidelines

31.2.1 DTMF command control how to use and program

Command control messages are voice messages and used to give status

information of the areas and outputs during the dial-in control.

Example 1: arming/disarming area A by DTMF

Access code for area A = 2525. The voice message for arming confirmation is 5

and disarming confirmation is “. The messages MUST be recorded correlated,

started with the arming message.

1. Dial in to Sintony 60 and wait until the communication is established.

2. Press <#> button at your phone to reset the digit counter.

3. Press

to hear the status of the areas (voice message from the

panel).

4. Press <*> to change the area status. The control panel will confirm with the

recorded voice message relating to the new status.

5. Hang up

You can change the area status as often as you want.

At any time you can press the

<#> button to reset the digit counter (i.e. by inserting a wrong number).

1 2 ... 162 163 164 165 166 167 168 169 170 171 172

Keine Kommentare

Siemens IC60 Bedienungsanleitung Seite 167