Siemens EF 711 Series Betriebsanweisung PDF herunterladen (Seite 127)

Configuring the Wireless AP

Configuring Wireless AP Settings

SCALANCE WLC711

User Guide, V8.11, 07/2012, C79000-G8976-C260-03 3-39

– Select WPA-PSK, and then clear the WPA v.1 option:

- Select WPA v.2.

- In the Encryption drop-down list, click AES only.

Note:

To achieve the strongest encryption protection for your VNS, Siemens recommends that you use WPA v.1 or

WPA v.2.

8. Click the QoS Policy tab.

9. In the Wireless QoS section, select the WMM option. Some 802.11n client devices will remain

at 54Mbps unless WMM is enabled.

Modifying Wireless AP W786-2HPW Radio Properties

The following section describes how to modify a Wireless AP W786-2HPW. For information on

how to modify a Wireless 802.11n AP W786C/W788C, see “Modifying Wireless 802.11n AP

W786C/W788C Radio Properties” on page 3-27.

To Modify the Wireless AP’s Radio Properties:

1. From the top menu, click Wireless APs. The Wireless AP screen is displayed.

2. Click the appropriate Wireless AP in the list. The AP Properties tab is displayed.

3. Click the Radio tab you want to modify. For more information on all Radio parameters, see

Table 3-9 on page 3-30.

Setting Up the Wireless AP Using Static Configuration

The Wireless AP static configuration feature provides the SCALANCE WLC711 solution with the

capability for a network with either a central office or a branch office model. The static

configuration settings assist in the setup of branch office support. These settings are not

dependent of branch topology, but instead can be employed at any time if required. In the branch

office model, Wireless APs are installed in remote sites, while the SCALANCE IWLAN Controller

is in a central office. The Wireless APs must be able to interact in both the local site network and

the central network. To achieve this model, a static configuration is used.

Note:

If a Wireless AP with a statically configured IP address (without a statically configured Wireless Controller

Search List) cannot register with the SCALANCE IWLAN Controller within the specified number of retries, the

Wireless AP will use SLP, DNS, and SLP multicast as a backup mechanism.

To Set Up a Wireless AP Using Static Configuration:

1. From the top menu, click Wireless APs. The Wireless AP screen is displayed.

2. Click the appropriate Wireless AP in the list.

3. Click the Static Configuration tab. The Static Configuration page displays.

4. Configure the settings on the Static Configuration page. You must:

• Select a VLAN setting for the Wireless AP

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 491 492

Keine Kommentare

Siemens EF 711 Series Betriebsanweisung Seite 127