Siemens EH.75M.11. Spezifikationen PDF herunterladen (Seite 2)

T400 Controller Facilities Manual

667/EB/20200/000 Page ii Issue 9

SAFETY WARNING

In the interests of health and safety, when using or servicing this equipment the following

instructions must be noted and adhered to:

(i) Only skilled or instructed personnel with relevant technical knowledge and

experience, who are also familiar with the safety procedures required when

dealing with modern electrical/electronic equipment are to be allowed to use

and/or work on the equipment. All work shall be performed in accordance with

the Electricity at Work Regulations 1989.

(ii) Such personnel must take heed of all relevant notes, cautions and warnings in

this Handbook, the Maintenance Handbook (667/HA/20200/000) and any

other Document or Handbook associated with the equipment including, but not

restricted to, the following:

(a) The equipment must be correctly connected to the specified incoming

power supply.

(b) The equipment must be disconnected/isolated from the incoming power

supply before removing any protective covers or working on any part

from which the protective covers have been removed.

a safe manner. If in doubt as to the correct procedure refer to the

Siemens instructions. CP No. 526.

(d) In the event of any person working elsewhere on the junction the Mains

Supply to the controller must be switched off and the Master switch

locked in the Off position using the Master Switch lock facility.

(667/1/21386/000).

WARNING

Removal of the electricity board fuse or switching off the controller or the Manual Panel

Signals On/Off switch does not guarantee isolation of the equipment.

1 2 3 4 5 6 7 ... 307 308

Keine Kommentare

Siemens EH.75M.11. Spezifikationen Seite 2