Siemens SPCK421 Spezifikationen PDF herunterladen (Seite 262)

Seismic Sensors

Configuring Video

262

Siemens AB

A6V10276959

Security Products

18.11.2011

20 Seismic Sensors

Vibration sensors, also called seismic sensors, are used to detect intrusion

attempts by mechanical means, such as drilling or making holes through walls or

safes.

Support for seismic sensors is available only if the installation type for the panel is

‘Financial’.

There are several ways to test seismic sensors. The simplest way to test seismic

sensors is by hitting a wall or safe and seeing if the zone opens during a walk test.

This means of testing is available with all types of seismic sensors.

If the seismic sensor is installed with a test transmitter, the following test options

are available:



Manual testing initiated at the keypad or with SPC Pro (not supported by the

browser);



Automatic testing on a periodic basis or when the panel is set using the

keypad.

The test transmitter is a small high frequency vibrator that is attached a short

distance from the sensor on the same wall. The test transmitter is wired to an

output on the panel or an expander.

Configuring Seismic Sensors in the Panel



Configure a seismic zone. Seismic sensors must be assigned to a zone. (See

Editing a Zone [➙ 165])

Using the Keypad



Select FULL ENGINEER->ZONES->(select zone)->ZONE TYPE->SEISMIC

1. Set the attributes for the zone.

2. Enable automatic testing of the sensor with the Seismic Test attribute.

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 295 296

Keine Kommentare

Siemens SPCK421 Spezifikationen Seite 262