Siemens SPCK421 Spezifikationen PDF herunterladen (Seite 99)

Engineer programming via the keypad

OUTPUTS

Siemens AB

A6V10276959

Security Products

18.11.2011

External Bell

This output type is used to activate the system external bell and is active when any

Area External Bell is active. By default, this output is assigned to the first output on the

controller board (EXT+, EXT-).

Note: An external bell output is automatically activated whenever a zone programmed

as an Alarm zone triggers an alarm in Fullset or Partset modes.

External Bell Strobe

This output type is used to activate the strobe on the system external bell and is active

when any area strobe is active. By default, this output is assigned to the strobe relay

output (Output 3) on the Controller board (NO, COM, NC).

Note: An external bell strobe output is automatically activated whenever a zone

programmed as an alarm zone triggers an alarm in Fullset or Partset modes. The

external bell strobe activates on a ’Fail to Set’ condition if the strobe on the ’Fail to Set’

option is checked in system options.

Internal Bell

This output type is used to activate the internal bell and is active when any area

Internal Bell is active. By default, this output is assigned to the second output on the

controller board (INT+, INT-).

Note: An internal bell output is automatically activated whenever a zone programmed

as an Alarm zone type triggers an alarm in Fullset or Partset modes. The internal Bell

activates on a ’Fail to Set’ condition if the Bell on the ’Fail to Set’ option is checked in

system options.

Alarm

This output turns on following alarm zone activation on the system or from any area

defined on the system.

Alarm Confirmed

This output turns on when an alarm has been confirmed. An alarm is confirmed when 2

independent zones on the system (or within the same Area) activate within a set time

period).

Panic*

This output turns on following activation of panic alarm zone types from any area. A

panic alarm output is also generated if a user duress event is generated or if the panic

option for the keypad is enabled.

Hold-up

This output turns on whenever a zone programmed as a Hold-up type zone triggers an

alarm from any area

Fire

This output turns on following a fire zone activation on the system (or from any area)

Tamper

This output turns on when a tamper condition is detected from any part of the system.

For a grade 3 system, if communication is lost to an XBUS device for greater than

100s, a tamper is generated and SIA and CIR reported events will send a tamper.

Medical

This output turns on when a medic zone is activated

Fault

This output turns on when a technical fault is detected

Technical

This output follows tech zone activity

Mains Fault*

This output activates when Mains power is removed

Battery Fault*

This output activates when there is a problem with the backup battery. If the battery

voltage drops below 11 V this output activates. The ’Restore’ option for this fault is only

presented when the voltage level rises to above 11.8 V.

Partset A

This output is activated if the system or any area defined on the system is in Partset A

mode

Partset B

This output is activated if the system or any area defined on the system is in Partset B

mode

Fullset

This output is activated if the system is in Fullset mode

Fail to set

This output activates if the system or any area defined on the system failed to set; it

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 295 296

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SPCK421 Spezifikationen Seite 99

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ziffernblock Siemens SPCK421