Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 128)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-128

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Remedy: Modify program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14159 Channel %1 block %2 more than two angles programmed with ROTS or

AROTS

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Frame rotations are described using space angles with the language commands ROTS or AROTS. A

maximum of two angles can be programmed.

Reaction: Correction block is reorganized.

Interpreter stop

Interface signals are set.

Alarm display.

Remedy: Modify program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14160 Channel %1 block %2 tool length selection without geometry axis

specification

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If for the tool length compensation with H word and G43/G44 in the ISO M mode using the MD 20380

TOOL_CORR_MODE_G43G44 the variant C is activated (the tool length acts in the programmed

axis), just one geometry axis together with H, if the MD 20384 TOOL_CORR_MULTIPLE_AXES is not

set. The alarm is then issued when either no geometry axis or more than one geometry axis has been

programmed together with H .

The programming of multiple axis is permitted when the MD 20384 TOOL_MULTIPLE_AXES = TRUE

has been set.

If no axis is specified, this is always an error.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Change MD 20380 TOOL_CORR_MODE or the part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14165 Channel %1 block %2 selected H number %3 does not match tool %4

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If a tool compensation is activated in the ISO M language mode (G43/G44), a tool number (H) must

be specified.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Change part program

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14170 Channel %1 block %2 illegal interpolation type with tool length

compensation

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 391 392

Siemens SINUMERIK 802D sl Spezifikationen Seite 128

Kommentare zu diesen Handbüchern

Siemens SINUMERIK 802D sl Spezifikationen Seite 128

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl