Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 38)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-38

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Remedy: Configure machine date $MN_HANDWHEEL_INPUT for a valid input for the corresponding hand-

wheel

Program Con-

tinuation:

Switch control OFF - ON.

4630 Invalid handwheel module for handwheel %1

Parameters: %1 = Handwheel module

Definitions: The reference in $MN_HANDWHEEL_MODULE for a corresponding entry in machine date array

$MN_HANDWHEEL_LOGIC_ADDRESS[] necessary for the configuration of PROFIBUS handwheels

is not available.

Reaction: Interface signals are set.

Alarm display.

Remedy: Configure the machine data $MN_HANDWHEEL_MODULE for the corresponding PROFIBUS hand-

wheel so that there is a valid reference to an entry in the machine data array

$MN_HANDWHEEL_LOGIC_ADDRESS[].

Program Con-

tinuation:

Switch control OFF - ON.

4631 Invalid handwheel slot for handwheel %1

Parameters: %1 = Handwheel slot

Definitions: The handwheel slot for handwheel %1 requested through the machine date

$MN_HANDWHEEL_INPUT is not available for PROFIBUS handwheels.

Reaction: Interface signals are set.

Alarm display.

Remedy: Configure machine date $MN_HANDWHEEL_INPUT to a valid handwheel slot for the corresponding

PROFIBUS handwheel.

Program Con-

tinuation:

Switch control OFF - ON.

4632 Logical PROFIBUS handwheel slot base address for handwheel %1 not

found

Parameters: %1 = Handwheel number

Definitions: The logical base address of the PROFIBUS handwheel slot in machine date array

$MN_HANDWHEEL_LOGIC_ADDRESS[] indexed in machine date $MN_HANDWHEEL_MODULE

was not found.

Reaction: Interface signals are set.

Alarm display.

Remedy: Check if $MN_HANDWHEEL_MODULE of the corresponding handwheel is correct. Check if indexed

logical base address of PROFIBUS handwheel slot in machine date array

$MN_HANDWHEEL_LOGIC_ADDRESS[] is correct.

Program Con-

tinuation:

Switch control OFF - ON.

5000 Communication job not executable %1

Parameters:

Definitions: The communication request (data exchange between NC and HMI,

for example: load an NC part program) cannot be executed due lack of memory. Cause: too many

parallel communication requests

Reaction: Alarm display.

Remedy: No remedy possible – the operation that produced to alarm must be repeated. Clear the alarm display

with Cancel.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 391 392

Siemens SINUMERIK 802D sl Spezifikationen Seite 38

Kommentare zu diesen Handbüchern

Siemens SINUMERIK 802D sl Spezifikationen Seite 38

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl