Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 284)

Overview of alarms 06/2007

Cycle alarms

2-284

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61175 Channel %1 block %2: angle of aperture _DF programmed too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The angle of aperture of the text in the engraving cycle is too small. This means that the text for

engraving does not fit in the specified angle.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter a larger angle of aperture.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61176 Channel %1 block %2: text length _DF programmed too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The text length in the engraving cycle is too short. This means that the text for engraving is longer than

the specified text length.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter longer text length

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61177 Channel %1 block %2: polar text length > 360 degrees

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In the engraving cycle, the polar text length must not exceed 360 degrees.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter shorter text length.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61178 Channel %1 block %2: code page not present

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified code page is not supported by the cycle.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use code page 1252.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61179 Channel %1 block %2: character does not exist, no.: %4

Parameters: %1 = Channel number

%2 = Block number, label

%4 = Character number

Definitions: The character entered in the text for engraving cannot be milled.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

1 2 ... 279 280 281 282 283 284 285 286 287 288 289 ... 391 392

Siemens SINUMERIK 802D sl Spezifikationen Seite 284

Kommentare zu diesen Handbüchern

Siemens SINUMERIK 802D sl Spezifikationen Seite 284

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl