Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 204)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-204

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

17190 Channel %1 block %2 illegal T number

Parameters: %1 = channel number

%2 = block number, label

Definitions: In the displayed block, access is made to a T number (tool number) that is not initialized and therefore

not available.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Check tool call in the NC part program:

Correct tool number T... programmed?

Tool parameters P1 - P25 defined?

The dimensions of the tool edge must have been entered previously either on the operator panel or

via the RS-232-C.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17191 Channel %1 block %2 T= %3 not existing, program %4

Parameters: %1 = channel number

%2 = block number, label

%3 = T number or T identifier

%4 = program name

Definitions: A tool identifier which the NC does not recognize was programmed.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: If the program pointer is at an NC block which contains the specified T identifier:

If the program is incorrect, remedy the error with a correction block and continue the program.

If the data block is missing, create one. You can do this by downloading a data block with all the

defined D numbers onto the NC (via MMC) and then continue the program.

If the program pointer is at an NC block which does not contain the specified T identifier:

The error occurred at an earlier point in the program where the T command appeared, but the alarm

was not output until the change command was detected.

If the program is incorrect - T5 programmed instead of T55 - the current block can be corrected with

a correction block; i.e. if only M06 is entered, you can correct the block with T55 M06. The incorrect

T5 line remains in the program until it is terminated by a RESET or end of program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17194 Channel %1 block %2 no suitable tool found

Parameters: %1 = channel number

%2 = block number, label

Definitions: An attempt was made to access a tool which has not been defined.

The specified tool does not permit access.

A tool with the desired properties is not available.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Check access to tool:

Are the parameters of the NC command correctly programmed?

Does the status of the tool prevent access?

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 391 392

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Spezifikationen Seite 204

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl