Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 78)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-78

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10793 Channel %1 block %2 second block missing during linear programming

with angles

Parameters: %1 = channel number

%2 = block number, label

Definitions: The second block is missing during programming of two straight lines with angle specification. This

situation only occurs if the first subblock is also the last block of a program, or if the first subblock is

followed by a block with a preprocessor stop.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10794 Channel %1 block %2 angle specification missing in 2nd block during

linear interpolation with angles

Parameters: %1 = channel number

%2 = block number, label

Definitions: The angle is missing from the second block during programming of two straight lines with angle spec-

ification.

This error can only occur if an angle was programmed in the preceding block, but no axis of the active

plane was programmed in that block.

The cause of the error may therefore also have been the intention to program a single straight line

with an angle in the previous block. In this case, exactly one axis of the active plane must be pro-

grammed.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10795 Channel %1 block %2 end point specification during angle programming

contradictory

Parameters: %1 = channel number

%2 = block number, label

Definitions: During programming of a straight line, both positions of the active plane and an angle were specified

(the position of the end point is over-specified), or the position of the programmed coordinate cannot

be reached with the specified angle. If a contour consisting of two straight lines is to be programmed

with angles, it is possible to specify the two axis positions of the plane and an angle in the second

block. The error can also occur if, due to a programming error, the preceding block cannot be inter-

preted as the first subblock of such a contour. A block is interpreted as the first block of a two-block

contour if an angle, but not an axis of the active plane, was programmed, and if the block is not already

the second block of a contour.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 391 392

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Spezifikationen Seite 78

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl