Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 133)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-133

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

New definition of the pole with polar angle and pole radius, referring to the reference point selected

with the G function.

G110 ... Last programmed point of the plane

G111 ... Zero point of the current WCS

G112 ... last pole

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Correct NC part program - the permissible input range for the polar angle is between the values -360

degrees and +360 degrees with a resolution of 0.001 degrees.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14270 Channel %1 block %2 pole programmed incorrectly

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: When defining the pole, an axis was programmed that does not belong to the selected processing

level.

Programming in polar coordinates always refers to the plane activated with G17 to G19. This also

applies to the definition of a new pole with G110, G111 or G112.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Correct the NC part program. Only the two geometry axes may be programmed that establish the cur-

rent machining plane.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14280 Channel %1 block %2 polar coordinates programmed incorrectly

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The end point of the displayed block has been programmed both in the polar coordinate system (with

AP=..., RP=...) and in the Cartesian coordinate system (axis addresses X, Y,...).

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Correct the NC part program - the axis motion may be specified in one coordinate system only.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14300 Channel %1 block %2 overlaid handwheel motion activated incorrectly

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Handwheel override has been called up incorrectly:

• 1.For positioning axes:

• Handwheel override programmed for indexing axis,

• No position programmed,

• FA and FDA programmed for the same axis in the block.

• 2. For contouring axes:

• No position programmed,

• G60 not active,

• 1. G group incorrect (only G01 to CIP).

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Change part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 391 392

Siemens SINUMERIK 802D sl Spezifikationen Seite 133

Kommentare zu diesen Handbüchern

Siemens SINUMERIK 802D sl Spezifikationen Seite 133

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl