Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 302)

Overview of alarms 06/2007

Cycle alarms

2-302

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61273 Channel %1 block %2: Insertion depth too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Insertion depth on chamfering too large.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Decrease the insertion depth.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61274 Channel %1 block %2: Invalid tool angle

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Invalid tool angle.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check tool angle.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61275 Channel %1 block %2: Target point violates software limit switch!

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Due to a swivel action, the end point is outside the software limit switches.

Alarm triggered by following cycle: E_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select another retraction plane or approach a suitable interpolation point.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61276 Channel %1 block %2: External tool diameter required for restrictions

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Outer tool diameter required in case of delimitations.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Specify the outer tool diameter.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61277 Channel %1 block %2: Tool diameter larger than restriction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Tool diameter larger than delimitation.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 391 392

Siemens SINUMERIK 802D sl Spezifikationen Seite 302

Kommentare zu diesen Handbüchern

Siemens SINUMERIK 802D sl Spezifikationen Seite 302

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl