Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 60)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-60

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

10630 Channel %1 block %2 axis %3 at working area limit %4

Parameters: %1 = channel number

%2 = block number, label

%3 = axis, spindle number

%4 = string (+ or -)

Definitions: The specified axis violates the working area limitation. This is recognized only in the main run either

because the minimum axis values could not be measured before the transformation or because there

is a motion overlay.

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Program a different motion or do not perform a motion overlay.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10631 Channel %1 axis %2 rests at working area limit %3

Parameters: %1 = channel number

%2 = axis, spindle

%3 = string (+ or -)

Definitions: The specified axis reaches the positive working area limitation in JOG mode.

Reaction: Alarm display.

Remedy: Setting data:

Check SD 43420 WORKAREA_LIMIT_PLUS and

SD 43430 WORKAREA_LIMIT_MINUS for work area limitation.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

10632 Channel %1 block %2 axis %3 reaches the coordinate system-specific

working area limit %4

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis, spindle number

%4 = String ( + or - )

Definitions: The specified axis violates the coordinate system-specific working area limitation. This is not detected

until the main run, either because the minimum axis values could not be determined before the trans-

formation or because there is an overlaid movement.

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Program other motion or do not perform overlaid motion.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10633 Channel %1 axis %2 is at coordinate system-specific working area limit

Parameters: %1 = Channel number

%2 = Axis, spindle

%3 = String ( + or - )

Definitions: The specified axis reaches the coordinate system-specific working area limitation in JOG mode.

Reaction: Alarm display.

Remedy: Check the system parameter $P_WORKAREA_CS_xx for the coordinate system-specific working

area limitation.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 391 392

Siemens SINUMERIK 802D sl Spezifikationen Seite 60

Kommentare zu diesen Handbüchern

Siemens SINUMERIK 802D sl Spezifikationen Seite 60

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl