Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 134)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-134

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

14310 Handwheel %1 configuration incorrect or inactive

Parameters: %1 = Handwheel number

Definitions: The inputs are using a drive with a drive number that does not exist or

an inactive drive for assignment of the handwheel (ENC_HANDWHEEL_MODULE_NR) or

an axis is using a measuring circuit which does not exist for the drive hardware.

Reaction: NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Check input configuration (machine data)

and/or drive hardware. Power-up is interrupted.

Program Con-

tinuation:

Switch control OFF - ON.

14320 Handwheel %1 used twice (%2) in channel %3 axis %4

Parameters: %1 = Handwheel number

%2 = Use

%3 = Channel

%4 = Axis

Definitions: Warning that the designated handwheel has been used more than once:

The second parameter supplies the explanation:

1: Block with axial handwheel override for this axis cannot be performed for this axis because the

handwheel for the axis is performing a DRF motion

2: Block with speed override for the path cannot be performed because the handwheel for the axis of

the path is performing a DRF motion

3: Block with contour handwheel cannot be performed because the handwheel for the axis of the path

is performing a DRF motion

4: PLC axis with axial handwheel override cannot be started immediately because the handwheel for

the axis is performing a DRF motion

5: The axis is a reciprocating axis with axial handwheel override, the oscillating motion cannot be

started immediately because the handwheel for the axis is performing a DRF motion

6: The DRF motion for this axis cannot be performed because an handwheel override for this axis with

the handwheel is active

7: The DRF motion for this axis cannot be performed because a speed override of the path with the

handwheel is active and the axis belongs to the path

8: The DRF motion for this axis cannot be performed because the contour handwheel with this hand-

wheel is active and the axis belongs to the path

9: The DRF motion for this axis cannot be performed because the axis is a PLC axis with handwheel

override that is active with the handwheel

10: The DRF motion for this axis cannot be performed because the axis as reciprocating axis with

handwheel override is active with this handwheel

Reaction: Alarm display.

Remedy: Use the handwheel for only one purpose.

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

14400 Channel %1 block %2 tool radius compensation active at transformation

switchover

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A change of transformation is not allowed when tool radius compensation is active.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Perform tool radius compensation in the NC part program with G40 (in a block with G00 or G01) before

performing a transformation change.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 391 392

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Spezifikationen Seite 134

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl