Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 33)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-33

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Program Con-

tinuation:

Switch control OFF - ON.

4300 Declaration in MD %1 is not allowed for axis %2.

Parameters: %1 = string: MD identifier

%2 = axis name, spindle number

Definitions: Geometry axes and spindles cannot be operated as concurrent positioning axes.

Reaction: Alarm display.

Remedy: Please inform the authorized personnel/service department. Reset MD 30450

IS_CONCURRENT_POS_AX for the axis concerned.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

4310 Declaration in MD %1 index %2 is not allowed.

Parameters: %1 = string: MD identifier

%2 = index in MD array

Definitions: The MD values must be written in the array in ascending order.

Reaction: Mode group not ready.

Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Correct the MD

Program Con-

tinuation:

Teileprogramm neu starten.Clear alarm with the RESET key in all channels of this mode group.

Restart part program.

4320 Axis %1 function %2 %3 and %4 not allowed

Parameters: %1 = string: Axis identifier

%2 = string: MD identifier

%3 = string: Bit

%4 = string: MD identifier

Definitions: The functions declared by the machine data specified cannot be activated at the same time for one

axis.

Reaction: Mode group not ready.

Channel not ready.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Deactivate one of the functions.

Program Con-

tinuation:

Switch control OFF - ON.

4340 Channel %1 block %2 invalid transformation type in transformation no.

Parameters: %1 = channel number

%2 = transformation number

Definitions: An invalid, i.e. undefined, number was entered in one of the machine data 24100 TRAFO_TYPE_1.

This alarm occurs only if a certain type of transformation is not possible in the specified control type.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Valid transformation type entered

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 391 392

Siemens SINUMERIK 802D sl Spezifikationen Seite 33

Kommentare zu diesen Handbüchern

Siemens SINUMERIK 802D sl Spezifikationen Seite 33

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl