Siemens SINUMERIK 802D sl Spezifikationen PDF herunterladen (Seite 85)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-85

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

10934 Channel %1 block %2 array for contour segmentation is set too small

Parameters: %1 = channel number

%2 = block number, label

Definitions: The program in which the stock removal contour is programmed contains too many blocks with

motions in both axes in the machining plane (CYCLE 95).

Reaction: Local alarm reaction.

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The number of blocks in the contour program must be reduced. You should check the distribution of

the contour over several programs.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10948 Channel %1 block %2 curve table %3: position jump at end of period

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Number of curve table

Definitions: A periodic curve table was defined in which the position of the following axis at the end of the table

was different to the position at the start of the table.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Correct the part program and start it again.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10962 Channel %1 block %2 function %3 not possible with path correction

Parameters: %1 = channel number

%2 = block number, label

%3 = function name

Definitions: With this software release, the specified function can not yet be used together with tool radius com-

pensation. Please modify the part program or obtain a higher software version.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

12000 Channel %1 block %2 address %3 programmed repeatedly

Parameters: %1 = channel number

%2 = block number, label

%3 = source string of address

Definitions: Most addresses (address types) may only be programmed once in an NC block, so that the block infor-

mation remains unambiguous (e.g. X... T... F... etc. - Exception: G and M functions).

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PROGRAM COR-

RECTION. The correction pointer positions on the incorrect block.

Remove from the NC program addresses that occur more than once (except for those where multiple

value assignments are allowed).

Check whether the address (e.g. the axis name) is specified via a user-defined variable (this may not

be easy to see if allocation of the axis name to the variable is performed in the program through com-

putational operations only).

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 391 392

Kommentare zu diesen Handbüchern

Keine Kommentare

Siemens SINUMERIK 802D sl Spezifikationen Seite 85

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Siemens SINUMERIK 802D sl